You are here: irt.org | RFCs | RFC3051 [ previous next ]
Network Working Group J. Heath
Request for Comments: 3051 J. Border
Category: Informational Hughes Network Systems
January 2001
IP Payload Compression Using ITU-T V.44 Packet Method
Status of this Memo
This memo provides information for the Internet community. It does
not specify an Internet standard of any kind. Distribution of this
memo is unlimited.
Copyright Notice
Copyright (C) The Internet Society (2001). All Rights Reserved.
Abstract
This document describes a compression method based on the data
compression algorithm described in International Telecommunication
Union (ITU-T) Recommendation V.44. Recommendation V.44 is a modem
standard but Annex B, Clause B.1, of the recommendation describes the
implementation of V.44 in packet networks (e.g., V.44 Packet Method).
This document defines the application of V.44 Packet Method to the
Internet Protocol (IP) Payload Compression Protocol (RFC 2393). RFC
2393 defines a method for applying lossless compression to the
payload portion of IP datagrams.
V.44 Packet Method is based upon the LZJH data compression algorithm.
Throughout the remainder of this document the terms V.44 Packet
Method and LZJH are synonymous.
Heath & Border Informational [Page 1]
RFC 3051 IP Payload Compression Using ITU-T V.44 January 2001 Table of Contents 1. Introduction...................................................2 1.1 General....................................................2 1.2 Background of LZJH Data Compression........................2 1.3 Intellectual Property Rights...............................3 1.4 Specification of Requirements..............................4 2. Compression Process............................................4 2.1 Encoder Dictionary.........................................4 2.2 Encoder Output.............................................4 2.3 Padding....................................................4 3. Decompression Process..........................................5 3.1 Compressed Datagram........................................5 3.2 Original Uncompressed Datagram.............................5 4. IPComp Association (IPCA) Parameters...........................5 4.1 Transform ID...............................................5 4.2 Security Association Attributes............................5 4.3 Manual configuration.......................................5 4.4 Minimum packet size threshold..............................6 4.5 Compressibility test.......................................6 5. Security Considerations........................................6 6. IANA Considerations............................................6 7. Acknowledgements...............................................6 8. References.....................................................6 9. Authors' Addresses.............................................7 10. Full Copyright Statement.......................................8 1. Introduction 1.1 General This document specifies the application of LZJH data compression, a lossless data compression algorithm, to IP datagram payloads. LZJH data compression is to be used in conjunction with the IP Payload Compression Protocol (IPComp) [RFC2393]. This document is written with the assumption that the reader has an understanding of the IPComp protocol. 1.2 Background of LZJH Data Compression LZJH is similar to the algorithm described in [LZ78] although it also has aspects which are similar to the algorithm described in [LZ77]. As such, it provides the execution speed and low memory requirements of [LZ78] with compression ratios that are better than [LZ77]. Originally developed for the satellite industry to compress IP datagrams independently, it is ideal for the IPComp application. The LZJH algorithm was modified to compress a continuous stream of data for a modem environment and this modified version is the basis for Heath & Border Informational [Page 2]
RFC 3051 IP Payload Compression Using ITU-T V.44 January 2001 Recommendation V.44. LZJH is an adaptive, general purpose, lossless data compression algorithm. It was selected by the ITU-T as the basis for Recommendation V.44 based on its performance across a wide variety of data types, particularly web HTML's, and based on its compression ratio characteristics, per MIP and memory utilized (as compared to other candidate algorithms). Its encoder is extremely efficient and can encode a two character string with 3 bits the second time that string is encountered in the data. A typical [LZ78] compression algorithm, such as V.42bis, is not suitable for an IPComp application since it takes too long to build up its dictionary, resulting in poor compression ratios on IP datagrams that are compressed independently. It also requires too many cycles to reset an [LZ78] dictionary between datagrams which adversely affects execution times. Similarly, a typical [LZ77] compression algorithm suffers in the IPComp application due to poor execution times. Hash tables, that help improve execution times when compressing continuous data, may cause deterioration of execution times in an IPComp application since they must be reset to an initial state between each datagram. LZJH not only has superior execution times when encoding or decoding packet data, but the reset of the dictionary between IP datagrams is trivial. The encoder requires only the initialization of a 256 word array and a handful of variables while the decoder requires only the initialization of a handful of variables. The LZJH algorithm uses a dictionary of 1525 entries, a total of only 16K of dictionary memory, for the IPComp application. During the encode process unmatched characters are encoded as ordinals and matched redundant strings of characters are encoded as codewords or string-extension lengths that represent the redundant strings. During the decode process the ordinals, codewords, and string- extension lengths are interpreted to re-create exactly the original datagram payload. The details of LZJH data compression can be found in [V44]. 1.3 Intellectual Property Rights The IETF has been notified of intellectual property rights claimed in regard to some or all of the specifications contained in this document. For more information, consult the online list of claimed rights. Heath & Border Informational [Page 3]
RFC 3051 IP Payload Compression Using ITU-T V.44 January 2001 1.4 Specification of Requirements The key words "MUST", "MUST NOT", "REQUIRED", "SHALL", "SHALL NOT", "SHOULD", "SHOULD NOT", "RECOMMENDED", "MAY", and "OPTIONAL" in this document are to be interpreted as described in [RFC2119]. 2. Compression Process The compression of datagrams is performed by a function called the Encoder. 2.1 Encoder Dictionary The transmitting entity MUST reset the encoder dictionary prior to processing each datagram's payload, as specified in clause 7.5.1 of [V44]. This ensures that each datagram's payload can be correctly decompressed independently of any other, as is required in an environment where datagrams may be lost or received out of order. The transmitting entity MUST flush unprocessed encoder data after the last byte of the datagram has been passed into the encoder such that the compressed datagram can be transmitted as a unit. The flush ensures that all data is processed and included in the output, i.e., the compressed datagram is complete and no data from the current datagram will be processed with the next datagram. 2.2 Encoder Output The input to the payload compression algorithm is an IP datagram payload. The output of the algorithm is a new (and hopefully smaller) payload. The output payload contains the input payload's data in either compressed or uncompressed format. The input and output payloads are each an integral number of bytes in length. If the uncompressed form is used, the output payload is identical to the input payload and the IPComp header is omitted. If the compressed form is used, the output payload is prepended with the IPComp header and encoded as defined in clause 6.3 of [V44]. 2.3 Padding A datagram payload compressed using LZJH always ends with a FLUSH codeword in the last one or two compressed data bytes. The FLUSH codeword may start in the 2nd to the last compressed data byte and end in the last compressed data byte or be totally within the last data byte. The FLUSH codeword is used to signal the end of the Heath & Border Informational [Page 4]
RFC 3051 IP Payload Compression Using ITU-T V.44 January 2001 compressed data and differentiate compressed data from padding. Any bits or bytes beyond the FLUSH codeword within the compressed payload are to be considered padding. The size of a compressed payload MUST be in whole octet units. 3. Decompression Process The decompression of datagrams is performed by a function called the Decoder. 3.1 Compressed Datagram If the received datagram is compressed, the receiver MUST reset the decoder dictionary prior to processing the datagram. This ensures that each datagram can be decoded independently of any other datagram in the event datagrams are lost or received out of order. Beginning with the decoder dictionary in the initial state, as specified in clause 7.5.2 of [V44], the receiver decodes the payload data field of the datagram according to the procedure specified in clause 6.4 of [V44]. 3.2 Original Uncompressed Datagram If the received datagram is not compressed, the receiver does not perform compression decoding and passes the payload data field of the datagram unaltered to the next protocol layer. 4. IPComp Association (IPCA) Parameters IKE [RFC2409] MAY be used to negotiate the use of the LZJH compression algorithm to establish an IPCA, as defined in [RFC2393]. 4.1 Transform ID The value of the LZJH Transform ID is IPCOMP_LZJH. This value is used to negotiate the use of the LZJH data compression algorithm using IKE. 4.2 Security Association Attributes There are no other parameters required for the negotiation of the LZJH compression algorithm using IKE. 4.3 Manual configuration The CPI value IPCOMP_LZJH is used for manually configured IPComp Compression Associations. Heath & Border Informational [Page 5]
RFC 3051 IP Payload Compression Using ITU-T V.44 January 2001 4.4 Minimum packet size threshold As stated in [RFC2393], small packets may not compress well. Informal tests using the LZJH algorithm on internet web pages and e- mail files show that the average payload size that typically produces expanded data is approximately 50 bytes. Thus, implementations may prefer not to attempt to compress payloads of approximately 50 bytes or smaller. 4.5 Compressibility test The LZJH algorithm, as described in [V44], is easily modified to incorporate an adaptive compressibility test, as referenced in [RFC2393]. Annex B of [V44] specifies the mechanism for including such a test in LZJH. 5. Security Considerations This document does not add any further security considerations to those discussed in [RFC2393]. 6. IANA Considerations This document does not introduce any new name spaces. The value of IPCOMP_LZJH is assigned from the IPsec IPCOMP transform identifier space defined in [RFC2407]. IANA has assigned a value of 4 for this purpose. 7. Acknowledgements This document is modeled upon [RFC2395]. 8. References [LZ77] Lempel, A., and Ziv, J., "A Universal Algorithm for Sequential Data Compression", IEEE Transactions On Information Theory, Vol. IT-23, No. 3, May 1977. [LZ78] Lempel, A., and Ziv, J., "Compression of Individual Sequences via Variable Rate Coding", IEEE Transactions On Information Theory, Vol. IT-24, No. 5, Sep 1978. [RFC2119] Bradner, S., "Key words for use in RFCs to Indicate Requirement Levels", BCP 14, RFC 2119, March 1997. [RFC2393] Shacham, A., "IP Payload Compression Protocol (IPComp)", RFC 2393, December 1998. Heath & Border Informational [Page 6]
RFC 3051 IP Payload Compression Using ITU-T V.44 January 2001 [RFC2395] Friend, R. and R. Monsour, "IP Payload Compression Using LZS", RFC 2395, December 1998. [RFC2407] Piper, D., "The Internet IP Security Domain of Interpretation for ISAKMP", RFC 2407, November, 1998. [RFC2409] Harkins, D. and D. Carrel, "The Internet Key Exchange", RFC 2409, November 1998. [V44] ITU Telecommunication Standardization Sector (ITU-T) Recommendation V.44 "Data Compression Procedures", November 2000. 9. Authors' Addresses Jeff Heath Hughes Network Systems 10450 Pacific Center Ct. San Diego, CA 92121 Phone: 858-452-4826 Fax: 858-597-8979 EMail: jheath@hns.com John Border Hughes Network Systems 11717 Exploration Lane Germantown, MD 20876 Phone: 301-601-4099 Fax: 301-601-4275 EMail: border@hns.com Heath & Border Informational [Page 7]
RFC 3051 IP Payload Compression Using ITU-T V.44 January 2001 10. Full Copyright Statement Copyright (C) The Internet Society (2001). All Rights Reserved. This document and translations of it may be copied and furnished to others, and derivative works that comment on or otherwise explain it or assist in its implementation may be prepared, copied, published and distributed, in whole or in part, without restriction of any kind, provided that the above copyright notice and this paragraph are included on all such copies and derivative works. However, this document itself may not be modified in any way, such as by removing the copyright notice or references to the Internet Society or other Internet organizations, except as needed for the purpose of developing Internet standards in which case the procedures for copyrights defined in the Internet Standards process must be followed, or as required to translate it into languages other than English. The limited permissions granted above are perpetual and will not be revoked by the Internet Society or its successors or assigns. This document and the information contained herein is provided on an "AS IS" basis and THE INTERNET SOCIETY AND THE INTERNET ENGINEERING TASK FORCE DISCLAIMS ALL WARRANTIES, EXPRESS OR IMPLIED, INCLUDING BUT NOT LIMITED TO ANY WARRANTY THAT THE USE OF THE INFORMATION HEREIN WILL NOT INFRINGE ANY RIGHTS OR ANY IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE. Acknowledgement Funding for the RFC Editor function is currently provided by the Internet Society. Heath & Border Informational [Page 8]