Feedback on: Exporting data to Word with Cold Fusion, April 06, 2000 at 07:32:25:

You are here: irt.org | About | Feedback | 1047 [ previous next ]

Feedback on:
Exporting data to Word with Cold Fusion

Sent by
Jim Holbrook on April 06, 2000 at 07:32:25:

Worth:
Very worth reading

Comments:
We have been doing rtf documents just like your article describes. But when we upgraded to 4.5 and then to 4.5.1 the cold fusion pages that created rft doucments starting taking from 30 to 45 MINUTES to run. All the time was in CF putting the page together.

Have you guys seen this?

Thanks,
Jim Holbrook

Other feedback on 'Exporting data to Word with Cold Fusion' - show all

Exporting data to Word with Cold Fusion - TlalocW February 18, 2008 at 12:14:07
Exporting data to Word with Cold Fusion - Jay April 22, 2002 at 14:35:36
Exporting data to Word with Cold Fusion - Alex April 10, 2002 at 14:57:00
Exporting data to Word with Cold Fusion - Andy Mcshane February 11, 2002 at 11:35:21
Exporting data to Word with Cold Fusion - Wes October 19, 2001 at 13:03:21
Exporting data to Word with Cold Fusion - Enrique Molina July 17, 2001 at 16:43:58
Exporting data to Word with Cold Fusion - michael toepfer March 09, 2001 at 14:17:09
Exporting data to Word with Cold Fusion - Patrick Kane January 05, 2001 at 06:38:31
Exporting data to Word with Cold Fusion - Neil Poole November 21, 2000 at 16:41:42
Exporting data to Word with Cold Fusion - paul celmer September 07, 2000 at 17:31:21
Exporting data to Word with Cold Fusion - Kevin Ulmer June 19, 2000 at 13:20:11
Exporting data to Word with Cold Fusion - Mike April 12, 2000 at 09:43:29
Exporting data to Word with Cold Fusion - Jim Holbrook April 06, 2000 at 07:32:25
Exporting data to Word with Cold Fusion - BONNETO June 08, 1999 at 08:49:00
Exporting data to Word with Cold Fusion - Christian Labrecque March 29, 1999 at 12:26:46
Exporting data to Word with Cold Fusion - Michael B March 05, 1999 at 11:21:56
Exporting data to Word with Cold Fusion - Michael B March 05, 1999 at 11:21:30